Brilliant DES-1221 Exam Dumps Get DES-1221 Dumps PDF [Q31-Q49]

Share

Brilliant DES-1221 Exam Dumps Get DES-1221 Dumps PDF

DES-1221 Dumps PDF - DES-1221 Real Exam Questions Answers

NEW QUESTION 31
A PowerStore T administrator discovers that only one port on each node is active and passing traffic. The other port is healthy and online, but total bandwidth is only half of what the customer expects. Which action could resolve the issue?

  • A. Configure VLT and Link Aggregation Control Protocol
  • B. Implement VLT and Dynamic Link Aggregation Group
  • C. Implement Dynamic Link Aggregation Group
  • D. Configure Link Aggregation Control Protocol and Dynamic Link Aggregation Group

Answer: A

Explanation:
Explanation/Reference: https://www.delltechnologies.com/resources/en-us/asset/white-papers/products/storage/ h18157-dell-emc-powerstore-clustering-high-availability.pdf

 

NEW QUESTION 32
Refer to the Exhibit.

Which port location in the graphic is used for network management connectivity on a PowerStore T?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: C

 

NEW QUESTION 33
What describes the remote replication Failover operation?

  • A. It is run automatically by the replication destination system in the event of a source system outage
  • B. It is run from the replication destination system by the administrator in the event of a source system outage
  • C. It is run automatically by the replication source system in the event of a source system outage
  • D. It is run from the replication source system by the administrator in the event of an outage on the system

Answer: B

Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/replication?
guid=guid-7641aeec-982e-4e4e-85fb-c50f525635db&lang=en-us

 

NEW QUESTION 34
Which ports are recommended for use as the interconnect between the two Dell supplied Data Switches connected to PowerStore?

  • A. Two 10 GigE
  • B. Two 25 GbE
  • C. Two 100 GigE
  • D. Four 1 GbE

Answer: B

Explanation:
Explanation/Reference: https://www.delltechnologies.com/en-us/collaterals/unauth/white-papers/products/storage/ h18241-dell-emc-powerstore-best-practices-guide.pdf (12)

 

NEW QUESTION 35
Refer to the Exhibit.

Which port location in the graphic is used for network management connectivity on a PowerStore T?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: C

 

NEW QUESTION 36
Use the PowerStore Manager simulator to configure the BaseEnclosure-NodeA-IoModule1-FEport0 as a replication port. When you have finished using the simulator, Click Next.

Answer:

Explanation:
Below are the exhibits solution for this simulation.








 

NEW QUESTION 37
A VM administrator uses their PowerStore user account and noticed they are unable to change their password. Why?

  • A. Validate user in Active Directory not set
  • B. Extended schema for Unix users in Active Directory not set
  • C. In settings > users: enable allow user to change password not set
  • D. VM Administrator role cannot set password

Answer: D

 

NEW QUESTION 38
Which administrator tasks are needed to increase the size of a VMFS datastore without the use of the VSI plugin, mounted to an external ESXi host?

  • A. Change the size of the datastore in vSphere and refresh the size of the volume in PowerStore Manager
  • B. Change the volume size in PowerStore Manager and restart the VASA service in vSphere
  • C. Change the volume size in PowerStore Manager and refresh the size of the datastore in vSphere
  • D. Change the size of the datastore in vSphere and restart the VAAI service in PowerStore Manager

Answer: A

Explanation:
Explanation/Reference: https://www.delltechnologies.com/en-us/collaterals/unauth/white-papers/products/storage/ h18116-dell-emc-powerstore-vmware-vsphere-best-practices.pdf

 

NEW QUESTION 39
Refer to the Exhibit.

A Network administrator is failing to discover a PowerStore T system using the PowerStore Discovery Utility. What might be the issue?

  • A. Discovery network uses only native VLAN
  • B. Port 54 has not been set to trunk mode
  • C. Dedicated port needs to be used for discovery network
  • D. Port 54 needs to be enabled

Answer: A

 

NEW QUESTION 40
A protection policy with snapshot and replication rules is applied to a file system. What is the result?

  • A. Both replication and snapshot rules get applied
  • B. Applying the protection policy to the file system fails
  • C. Snapshot rules get ignored and only replication rules get applied
  • D. Replication rules get ignored and only snapshot rules get applied

Answer: D

Explanation:
Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/data-protection-in- powerstore?guid=guid-19c6d0e1-fa20-4fb5-9983-61c17abaf21b&lang=en-us

 

NEW QUESTION 41
Refer to the Exhibit.

A Network administrator is failing to discover a PowerStore T system using the PowerStore Discovery Utility. What might be the issue?

  • A. Port 54 has not been set to trunk mode
  • B. Port 54 needs to be enabled
  • C. Discovery network uses only native VLAN
  • D. Dedicated port needs to be used for discovery network

Answer: D

 

NEW QUESTION 42
What are the IP requirements for ICW on PowerStore X and PowerStore T models?

  • A. PowerStore T requires four management IP addresses and PowerStore X requires six management IP addresses
  • B. PowerStore T requires five management IP addresses and PowerStore X requires six management IP addresses
  • C. PowerStore T requires seven storage IP addresses and PowerStore X requires three storage IP addresses
  • D. PowerStore T requires three storage IP addresses and PowerStore X requires five storage IP addresses

Answer: B

 

NEW QUESTION 43
Refer to the Exhibit.

Which port location in the graphic is used for network management connectivity on a PowerStore T?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: C

 

NEW QUESTION 44
What does a Storage Administrator need to consider about Resource Balance when assigning volumes?

  • A. Whether the appliance is online
    Appliance failure status
    Cluster utilization
  • B. Whether the appliance is offline
    Appliance failure status
    Capacity utilization
  • C. Whether the Node is offline
    Appliance failure status
    Node utilization
  • D. Whether the Cluster is offline
    Node failure status
    I/O utilization

Answer: B

 

NEW QUESTION 45
What is the recommended Windows multi-pathing policy for block volumes on a PowerStore array?

  • A. Round-Robin
  • B. FailOver
  • C. Least QueueDepth
  • D. Least Weighted Paths

Answer: A

Explanation:
Reference: https://www.delltechnologies.com/en-us/collaterals/unauth/technical-guides-support-information/ products/storage-2/docu5134.pdf

 

NEW QUESTION 46
What describes the remote replication Failover operation?

  • A. It is run automatically by the replication destination system in the event of a source system outage
  • B. It is run from the replication destination system by the administrator in the event of a source system outage
  • C. It is run automatically by the replication source system in the event of a source system outage
  • D. It is run from the replication source system by the administrator in the event of an outage on the system

Answer: B

Explanation:
Reference:
https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/replication?guid=guid-
7641aeec-982e-4e4e-85fb-c50f525635db&lang=en-us

 

NEW QUESTION 47
Match the CLI command to the appropriate configuration.

Answer:

Explanation:

 

NEW QUESTION 48
A Storage Administrator removed an appliance from the cluster. What is the status of the removed appliance's licenses?

  • A. Licenses becomes void
  • B. Licenses are erased
  • C. No licensing impact
  • D. New licenses are created

Answer: B

 

NEW QUESTION 49
......


EMC DES-1221 Exam Syllabus Topics:

TopicDetails
Topic 1
  • Describe the PowerStore Migration feature and process
  • Provide an overview of PowerStore architecture and hardware
Topic 2
  • Identify the PowerStore Migration requirements and capabilities
  • Describe the PowerStore system and use cases
Topic 3
  • Configure the migration feature to import data from supported sources
  • Describe Ethernet cabling for PowerStore
Topic 4
  • Configure the migration requirements and capabilities
  • Demonstrate back-end for PowerStore
Topic 5
  • Identify PowerStore system fault LEDs
  • Identify the PowerStore system configurations and models
Topic 6
  • Describe and perform PowerStore software upgrade
  • Demonstrate front-end cabling for PowerStore models
Topic 7
  • Discover and perform initial system configuration of PowerStore
  • Describe and configure intercluster data migration
Topic 8
  • Configure host and client access to PowerStore block, file, and VMware storage
  • Perform PowerStore installation planning
Topic 9
  • Perform PowerStore intercluster data migration operations
  • Provision and configure block, file, and VMware storage
Topic 10
  • Perform PowerStore local and remote data protection operations
  • Configure Ethernet switching for PowerStore

 

Valid DES-1221 Test Answers & EMC DES-1221 Exam PDF: https://www.validbraindumps.com/DES-1221-exam-prep.html

Realistic DES-1221 Exam Dumps with Accurate & Updated Questions: https://drive.google.com/open?id=10CUDHTXY_-pqkxiS2ANeGvQ7Ki_1zsKv