[Oct 24, 2021] Latest CCNP Service Provider 300-510 Actual Free Exam Questions
CCNP Service Provider 300-510 Dumps Updated Practice Test and 104 unique questions
Cisco 300-510 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
| Topic 13 |
|
| Topic 14 |
|
| Topic 15 |
|
Difficulty in Writing Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam
The Implementation of the Cisco Service Provider VPN Services (300-510) certification is one of the most important certifications that applicants can have on their CV. One of the biggest challenges for many candidates is to use the Internet to find so many details that make it impossible for them to believe, which would be beneficial for them to choose the correct 300-510 SPRI practice test.
However, applicants can clear the examination with the correct concentration and the correct preparatory material. ValidBraindumps have the most up to date 300-510 SPRI dumps that allows a clear understanding of the pattern in questions raised by these dumping aspirants with real certification. The experts track qualification questions for all the changes in the course. Certification problems also require realistic research, which is an ideal forum to test the knowledge that is collected. For the study content, refer to the links below.
NEW QUESTION 15
Refer to the exhibit.
What is the effect of this configuration?
- A. It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds.
- B. It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.
- C. It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds.
- D. It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds.
Answer: B
NEW QUESTION 16
Which statement about enabling segment routing for IGPs is true?
- A. Segment routing can be enabled only globally
- B. Segment routing must first be enabled under then routing process and then globally
- C. Segment routing must first be enabled globally and then under the routing process
- D. Segment routing can be enabled only under the routing process
Answer: C
NEW QUESTION 17
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?
- A. Configure the send and accept lifetime under key 1
- B. Change HMAC-MD5 to HMAC-SHA1-12
- C. Change HMAC-MD5 to MD5
- D. Change HMAC-MD5 to HMAC-SHA1-20
Answer: A
NEW QUESTION 18 
Refer to the exhibit. Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A. R3
- B. R2
- C. R4
- D. R5
Answer: B
NEW QUESTION 19
What is used by SR-TE to steer traffic through the network?
- A. dynamic rules
- B. shortest path calculated by IGP
- C. explicit maps
- D. path policy
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/segment-routing/configuration/guide/b-seg-routing-cg-asr9k/b-seg-routing-cg-asr9k_chapter_0100.html
NEW QUESTION 20
Refer to the exhibit.
A network operator is working to deploy a Unified BGP design and allow it to be available only in selected markets and services in the future. The label allocation is not functioning as desired. Which action will fix the issue?
- A. Remove the allocate-labels command.
- B. Remove the route policy and only configure "allocate-label".
- C. Reconfigure the route-policy ALL_LABELS to match all after the drop.
- D. Reconfigure the route-policy ALL_LABELS to pass.
Answer: D
NEW QUESTION 21
Refer to the exhibits.
A network operator is troubleshooting packet loss seen from the R1 loopback interface to the R2 loopback interface over the core network. The operator is attempting to identify the next leg in the path from PE1.
Which interface and label path should the operator investigate next?
- A. PE1 - Gi0/0/0/3 - forwarding label 24002
- B. PE1 - Gi0/0/0/2 - forwarding label 24002
- C. PE1 - Gi0/0/0/2 - forwarding label 24001
- D. PE1 - Gi0/0/0/3 - forwarding label 24001
Answer: D
NEW QUESTION 22
Refer to the exhibit
Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A. R3
- B. R2
- C. R4
- D. R5
Answer: B
NEW QUESTION 23
Refer to the exhibit.
Why is neighbor 10.1.5.5 stuck in "2WAY" state?
- A. OSPF authentication has failed between R2 and 10.1.5.5
- B. Router ID 10.1.5.5 is not reachable from R2
- C. It is an expected behavior when OSPF network type is broadcast
- D. OSPF parameters (Area ID or hello interval) are mismatched between R2 and 10.1.5.5
Answer: C
NEW QUESTION 24
Refer to the exhibit.
Which effect of this configuration is true?
- A. It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds
- B. It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.
- C. It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds
- D. It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds
Answer: B
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_bgp/command/irg-cr-book/bgps1.
html#wp1552800140
NEW QUESTION 25
Which task is performed when troubleshooting LDP?
- A. Verify that MPLS is disabled globally and enabled on the necessary interfaces in a per-interface basis
- B. Execute the traceroute utility to generate information about the labels used along the path
- C. Verify that Cisco Express Forwarding has been disabled on the network
- D. Execute the ping utility to generate information about the MAC addresses used along the path
Answer: B
NEW QUESTION 26
Refer to the exhibit.
XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: A
Explanation:
Reference:
b_routing_cr41crs/b_routing_cr41crs_chapter_01000.html#wp3850885229
NEW QUESTION 27
Refer to the exhibit.
Which two commands must the engineer configure for the company's PIM-PIM network to enable Auto-RP mappings to be sent over the FastEthernet0/0 interface without affecting normal operation? (Choose two)
- A. enable sparse-mode
- B. enable Auto-RP announcements
- C. enable sparse-dense mode
- D. enable auto-rp listener
- E. enable dense mode
Answer: C,D
NEW QUESTION 28
Refer to the exhibit.
Which statement about this configuration is true?
- A. Router 1 receives up to two paths from neighbor 192.168.1.1 for all routes in the same AS
- B. Router 1 receives only the best path from neighbor 192.168.1.1
- C. Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
- D. Router 1 sends up to two paths to neighbor 192.168.1.1 for all routes
Answer: C
NEW QUESTION 29
What is the purpose of a BGP confederation?
- A. It redirects traffic away from route reflectors, which reduces their operating load.
- B. It limits the number of routes a device receives from its peers, which reduces CPU load.
- C. It reduces the number of iBGP peers and increases stability.
- D. It improves service by increasing the number of simultaneous iBGP peering sessions.
Answer: C
NEW QUESTION 30
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?
- A. ipv4 pim bidir-enable
- B. ip multicast-routing
- C. ip pim bidir
- D. ip pim bidir-enable
Answer: D
Explanation:
Reference:
imc_basic_cfg.html
NEW QUESTION 31
Refer to the exhibits.
A network operator is troubleshooting packet loss seen from the R1 loopback interface to the R2 loopback interface over the core network. The operator is attempting to identify the next leg in the path from PE1. Which interface and label path should the operator investigate next?
- A. PE1 - Gi0/0/0/3 - forwarding label 24002
- B. PE1 - Gi0/0/0/2 - forwarding label 24002
- C. PE1 - Gi0/0/0/2 - forwarding label 24001
- D. PE1 - Gi0/0/0/3 - forwarding label 24001
Answer: D
NEW QUESTION 32
Refer to the exhibit.
An engineer is addressing an IS-IS design issue which is running within the topology. All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet. Which statement about the design is true?
- A. All links have equal cost if the default metric is used
- B. R1 prefer to use R5 as the next hop to reach R4
- C. R5 prefers to use R4 as the next hop for all routes
- D. R4 prefer to reach R5 using R1 as the next hop
Answer: A
NEW QUESTION 33
Refer to me exhibit.
A network engineer sets up a multihoming eBGP topology where multiple Autonomous Systems connect to ASN 64501. The engineer wants to block all the routers coming from ASN 64502. but allow all the others. For that purpose, the following AS Pam prefix 1st s being used:
What must be fixed to achieve this result?
- A. The AS-PATH filter must be defined inside the route-map mode
- B. The statement must CM modified with ip as path access list 1 deny A64502$
- C. At the end ip as-path access-list 10 permit .* must be included
- D. The statement must be modified with ip as-path access-list 1 deny _64502_
Answer: C
NEW QUESTION 34
Refer to the exhibit.
A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired. Where should the soft preemption be applied to solve the issue?
- A. under the tunnel-te1 interface on PE1
- B. on the tail-end device for tunnel-te1 192.168.0.7
- C. explicitly for tunnel-te 1 under the Cisco MPLS TE configuration mode after the timeout setting
- D. Under the interface Loopback0 necessary for this deployment type.
Answer: A
NEW QUESTION 35
Refer to the exhibit.
After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most likely?
- A. The two routers have the same network ID.
- B. The two routers have different IS-types.
- C. The two routers have the same area ID.
- D. The two routers cannot authenticate with one another.
Answer: D
NEW QUESTION 36
Which two statements about route reflectors are true? (Choose two.)
- A. If a router received an iBGP route with the originator-ID attribute set to its own router ID, the route is discarded.
- B. Routes received from nonclient peers are reflected to route reflector clients as well as nonclient peers.
- C. Routes received from a route reflector client is reflected to other clients and nonclient peers.
- D. If a route reflector receives a route with a cluster-list attribute containing a different cluster ID, the route is discarded.
- E. Routes received from nonclient peers are reflected to route reflector cluster as well as OSPF peers.
Answer: A,C
Explanation:
Explanation/Reference: http://www.networkers-online.com/blog/2009/02/bgp-route-reflector-basics/
NEW QUESTION 37
......
The benefit of obtaining the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam Certification
The Cisco Service Provider VPN Services (300â515 SPRI) test is not simpler and unless well prepared, can prove to be a very tough exam. If competent 300-510 SPRI exam dumps are researched and evaluated on 300-510 SPRI practice exams, the exam difficulty can be reduced. The benefits are listed below:
- Cisco certified professionals can manage complex projects and issues
- Cisco certifications enhance the credibility of certified professionals
- Cisco certified professionals can provide a higher level of customer satisfaction
- If the applicant has the desire to transfer into a company to a higher-paying role. As always, this credential will help.
- Cisco certifications improve career prospects
- Cisco certifications improve earning
- When a company recruits or promotes an employee, human resources are responsible for the decision. Now, although applicants may have an IT history, they make their decisions in a way that records several different variables. One thing is that applicants, like the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) certified, have formal qualifications.
- Cisco certifications improve job productivity
The 300-510 SPRI exam certifies your knowledge of implementing service provider advanced routing technologies including routing protocols, policy language, MPLS, and segment routing. After you pass 300-510 SPRI, you earn the Cisco Certified Specialist - Service Provider Advanced Routing Implementation certification, and you satisfy the concentration exam requirement for the CCNP Service Provider certification.
Verified 300-510 dumps Q&As - 100% Pass from ValidBraindumps: https://www.validbraindumps.com/300-510-exam-prep.html
Latest 100% Exam Passing Ratio - 300-510 Dumps PDF: https://drive.google.com/open?id=1hZFia1RCbBpF7HYMi1qGfocCl7ZxmHhs